Hello, I am having an issue with displaying point cloud POD files. I am not sure if this might be an issue caused from insufficient hardware, software settings, or some form of built-in cap within the software. Below is a screenshot of what I am talking about. I am trying to load hundreds of POD files from a client and typically I am able to attach 200 POD files without this issue showing up (which typically encompasses somewhere around 6.7 Billion points). At some point above 200 POD files, the points seem to start displaying just as R/G/B/W blocks. I haven't found any consistency to at what point this happens and haven't been able to determine if it is a result of a certain number of files or a number of points. I have been loading the POD files in batches of 50. Sometimes this shows up in the 201-250 batch and sometimes in the 251-300 batch. I have verified that these files loaded by themselves display normally so it is not a problem with particular files. The laser scan vendor wasn't very good with cleaning up the scans that they gave us and for reference there are a total of >800 POD files totalling 280GB of data that we would like to load and view. I realize that it may not be feasible to do it all at once, but I wanted to ask the community to see if anyone has encountered this or has a solution. Thanks in advance.
↧