Just to be sure. Did you get any errors (related to tile production) ?? If yes then check tiling for your model. If you divide your model to smaller tiles there may be a problem on the "edges" with not enough photo data to create tiles. One of the solution is to use bigger tiles. On the other hand there also may be something wrong with your AT. See attached image. I highlighted on green photographs which were probably not included (??) in your AT...most of your photos have "camera mark" pointing down but those highlighted by me are only dots. You can also see on your AT that there are more holes in it, especially in locations where photographs are musing (not included in AT). It's not always the case as if you have enough overlap some photographs in AT even when missing can be excluded and AT will be OK. Your AT report should give you a warning how many photographs could not be used in AT. As an example I attached image with one of my jobs. Notice that all of the photographs have camera "mark" which means they all were used in AT.
↧